Note: This item is available for pick up from our Factory at Hemmant, or can be delivered using a Dangerous Goods (DG) freight coupon (link)

Remember that when buying many items at the one time from our store, you can click on the freight discount box at the time of your checkout, and receive a freight discount (this does not apply to DG Dangerous Goods freight)

Epoxy Timber Preserver is a two-pack, solvent-based polyamide-cured epoxy primer designed to seal timber/plywood to prevent water and other chemicals from damaging timber, excellent for sealing all forms of porous surfaces before the application of topcoats, adhesives, and sand-filled epoxy trowel flooring. This may be used on metal, wood, concrete, and masonry surfaces and most plastics and cures to affect a tough penetrating membrane resistant to water and mild aqueous chemical solutions.

Mixing Ratio 1 part “A” Resin to 1 part “B” Hardener by VOLUME.

Allow the mixed Epoxy Timber Preserver to stand for 5-10 minutes before using.

Coverage is approximately 1L covers 24 square meters per coat when applied on a glass surface. Obviously, depending on the timber and the surface condition? more Epoxy Timber Preserver will be needed.

* SURFACE PREPARATION - Before applying any epoxy resin-based system, ensure the substrate has been correctly prepared and is dean and dry.

Please Note: This product is a very pure epoxy. And it acts similarly just like pure honey (pure epoxies act similar to honey in that, during winter, honey is extremely thick and yet in summer, that same honey is very thin and runny). So, to it is with epoxies. And just like pure honey which sometimes turns into sugar, pure Epoxy resin can act similarly and develop crystals (usually in part A). This is not from faulty resin, but the common thought is that it is from the cyclic hot days and cold nights when stored. An easy fix is to heat the jugs up in very hot water for about 30 mins and this will restore the resin to be perfectly clear. That heating is also a good thing to help remove air bubbles trapped in the epoxy due to transportation.

If I have to do a critical pour or application, as a tip, I heat the jugs in near-boiling water the day before the pour and let them cool down for the day of my pour. Additionally, when mixing the two parts, I decant into the mixing container by pouring down the side of the container using the lower viscosity hardener first, followed by the base resin. All this effort is to try to limit any possible air bubbles that could ruin the finished product. Even when mixing, I use a wide rule and do not even take it off the bottom of the mixing container. Mixing is so important to get the best results and can take 3 mins.

Note: Always close the caps after each usage, otherwise the contents might turn cloudy and skin might form if the bottle cap left open. Larger quantities are available upon request, please contact us.

The new help pages are progressively populated. Please click on the link that follows: HELP PAGES

This product is manufactured fresh every week in Australia and is supplied to several suppliers who in turn market this product with various brand labels. This product may be delivered with a different label than as shown in the pictures, but the contents will be identical and the specifications the same in every respect).

See AACI Safety Data Sheet here SDS

Click the table above to purchase your Dangerous Goods Coupon that is required when this product is set for delivery

Always wear gloves and a dust mask and avoid breathing vapours of resin or dust residue. Accessories

*Pictures for example purposes only.