Teachers love the fact that it is non-toxic and a non-dangerous good (you can pop it into the post). So perfect for schools doing resin classes.

Platinum Art Class epoxy is just one of over 50 different resins from Platinum and a range that includes the world-famous Platinum 360+ (sold around the world) and the hugely popular Platinum Ultraclear.

Both working times and cure times of Platinum Art Class epoxy are subject to weather conditions.

Technical information is listed below:

1 Application: Platinum Art Class is an epoxy resin cured at normal temperature and low temperature. It is easy to operate, fast curing, it has strong adhesion, and can be further cured by heating if required. It is ideal for Resin Artists creating wave effects but is equally specially used for electronic component casting, metal bonding, electronic product bonding, wood bonding, hard material bonding and mould infusion, as well as other electronic parts insulation, moisture-proof casting to 10mm.

Individual kits can be purchased or in bulk for those creating classes (good discounts when purchasing in bulk)

TSD and SDS are available from the manufacturer.

• Non Toxic
• Perfect for wave and lace effects
• Food Safe
• Mix easily 1:1 ratio
• Sets in 1 hour
• Ideal for Art Class - take your work home
• Safe to mail as a non Dangerous Goods
• Rock hard, hi gloss surface, Hi temp, scratch resistant
• 

Please Note: This product is a very pure epoxy and acts similarly to pure honey (during Winter, honey is extremely thick, and yet in Summer, that same honey is very thin and runny). So too it is with epoxies. Just like pure honey, which sometimes turns into sugar, pure Epoxy resin can act similarly and develop crystals (usually in part A). This is not from faulty resin, but the common thought is that it is from the cyclic hot days and cold nights when stored. An easy fix is to heat the jugs in very hot water for about 30 mins and this will restore the resin to be perfectly clear. That heating is also a good thing to help remove air bubbles trapped in the epoxy due to transportation.

If I have to do a critical pour or application, as a tip, I heat the jugs in near-boiling water the day before the pour and let them cool down for the day of my pour. Additionally, when mixing the two parts, I decant into the mixing container by pouring down the side of the container using the lower viscosity hardener first, followed by the base resin. All of this extra effort is to try to limit any possible air bubbles from forming that could ruin the finished product. Even when mixing, I use a wide rule and do not take it off the bottom of the mixing container. Mixing is crucially important to get the best results and can take from 3 - 5 minutes.

Note: Always close the caps after each usage, otherwise the contents might turn cloudy and skin might form if the bottle cap is left open. Larger quantities are available upon request, please contact us.

The new help pages are progressively populated. Please click on the link that follows: HELP PAGES

This product is manufactured fresh every week in Australia and is supplied to several suppliers who in turn market this product with various brand labels. As such this product may be delivered with a different label than as shown in the pictures, but the contents will be identical and the specifications the same in every respect).

Always wear gloves and a dust mask and avoid breathing vapours of resin or dust residue. Accessories

********* Pictures for example purposes only. AACI product pictures are not yet shown here. Please stay with us while we update all of our product pictures ************